XTool D8S Smart Diagnostic Tool & Key programmer With 38+ Maintenance Functions, Bi-Directional Control
The XTool D8S is an automotive smart diagnostic system with 8 inches LCD display, which is designed for mechanics, electricians, and car maintenance shops. It supports full OBDII function and automotive diagnostics for full-system, including reading ECU version information, reading fault codes, live data, and freeze frames. 38 common special functions are supported, Namely: throttle matching, ABS bleed, maintenance light reset, EPB test, SAS, BMS, injector coding, DPF regeneration, and TPMS reset. 98% vehicle coverage, work on 85+ brands, 10000 cars.
All XTOOL Products: Https://Www.Diatools.Co.Za/Brand/Xtool/
Advantages for XTool D8S:
- Intelligent Topology Map.
- Bi-Directional Control: Receive information and send the commands to the system/components to perform active tests like EVAP Test, Fuel Pump Test, Fuel Injector Test, Cycling A/C Clutch On/Off, Cooling Fan Test, ect.
- Full-System Diagnostic: Perform OE-Level diagnosis on all available systems. Support ECU information, read and clear DTC, live data and freeze frame and special function under system menus.
- Support CAN FD and DOIP Protocols.
- Offline Programming Supported: Support programmable module installation for Ford, Lincoln and Mazda.
- 35+ Maintenance Functions: Include top popular maintenance functions, like ABS Bleeding, Key Programing, Injector Coding, Oil Reset, EPB, ect.
- 3 Years Free Updates Via Official Website Http://Www.Xtooltech.Com/
The XTool D8S automotive diagnostic computer is capable of in-depth OE level (same level capabilities as dealer-tools) diagnostics that is previously available to dealer-tool only. D8 can access and scan all available vehicle modules like ABS, SRS (Airbag), ECM, TCM, PCM, BCM, IMMO, Chassis, Suspension, parking brake system, HVAC, lighting system, Radio systems and etc. to pinpoint fault locations for efficient car repair or component replacement, turn off warning lights and reset monitors.
Read & clear codes, show DTC definitions, turn off Check Engine Light (MIL), ABS / Airbag / Transmission warning lights, reset monitors.
Show live data stream in text or graph, and export as CSV file like misfire data, engine rpm, transmission oil temperature, mass airflow sensor data, long/short fuel trim, fuel pressure, actual fuel temperature vs desired fuel temperature, cylinder balance rates, fuel loop status (Fuel System 1/2 Status) and etc.
ECU Coding & Online Coding, VAG Guided Functions:
- Online ECU Coding for VW, for Audi, for Skoda.
- Online Calibration.
- Online Parameterization.
- Components Matching.
- Guide Functions for V.A.G vehicles.
Flash Hidden Functions & Customize Car Settings:
- Rear-view mirror folding.
- Disable daytime running light.
- Disable seat belt alarm beep.
- Remove maximum speed limiter.
Note: ECU Coding works for specific VW, for Audi, for Skoda vehicles only. Flash Hidden Functions work on specific vehicles. Please check compatibility with VIN Before purchase!
XTool D8 can NOT program ECUs or reflash modules like ECM, PCM, BCM and etc.
Full Bi-Directional Controls & Various Active Tests (Bi-Directional Control) as You Command:
This 8” automotive diagnostic tool offers full bi-directional control capabilities over various vehicle sub-systems, and components to test the integrity like A/C Clutch, Fuel Injectors, ABS Pump Motor, Cooling Fan, Solenoid Valves, Relays, Interior Lighting, Window, Door, Sunroof, Car Wipers, and etc.
- Fuel Injector Balance, Fuel Pump Enable, Fuel Trim Enable.
- Fuel Injector Tests, Injector Buzz Test, Injector Kill Tests, Injector Cut Out Test.
- Cylinder Deactivation.
- A/C Compressor Clutch Relay On/Off.
- Cycling ABS Pump Motor.
- EVAP Tests: EVAP Purge Solenoid Valve, EVAP Vent Solenoid Valve, EVAP Purge/Seal.
- EGR System Test>Switch on/off car wipers.
- Rolling up/down car windows/doors/sunroof.
- Cooling fan motor command>Interior lighting test.
- High beam test.
XTool D8S Advance Special Functions:
Other Most-Used Service Functions: Power Balance (for Ford, GM), Throttle Relearn, Suspension Calibration, Trans Adaptation (Gearbox Match), TPMS Reset, Seat Match, Window / Door / Sunroof, Headlight, Airbag Reset (airbag reset and clear airbag crash data), Electronic Pump Activation (for BMW, MINI) Transport Mode, Tire Upgrade, Tooth Learning, Air / Fuel Reset, Start / Stop Reset, Language Change, EEPROM.
Advanced Special Functions: ABS Initialization, Zero Point Calibration, Yaw Rate Sensor Calibration, Seat Weight Sensor Calibration, Idle Relearn, VGT Turbo Calibration, Linear Solenoid Valve Calibration, Fuel Trim Reset, Alcohol Composition Reset, Transmission Oil Counter Reset, Transmission Quick Learn, CAM Crank Relearn, Crankshaft Pos. Variation Learn, VIN Relearn, Radio Setup, Pilot Quantity Learning, Fuel Density Learning Value Reset, Transmission Adaptive Value Reset, HVAC Actuat0r Calibration, Engine Test On/Off (Forced Engine Activation Mode for Hyundai), ADAS Calibration and more for you to explore.
Powerful Key Programming Functions:
The IMMO service can disable a lost vehicle key and program the replacement key fob. One or more replacement key fobs can be programmed. like programming new key fobs, Read PIN code/pin code calculation, check number of keys, Generate key, Add key, All key lost.
- Read Pincode.
- Generate key, Key Refresh.
- Make Dealer Key.
- All Key Lost.
- Immobilizer Data Reading & Writing.
- Backup IMMO Data.
- Remote Frequency Detection.
- Immobilizer Module Replacement.
- IMMO ECU Reset & Coding.
- Mercedes infrared Key Read/Write.
– And more. (The D8S is Compatible with the Following) (Optional)
- Work with KC100 for VW 4th/5th IMM.
- KC501 For Benz infrared key.
- KS01 (need Kc100 together) For Toyota all key lost.
- M821 (need with kc501) for Benz all key lost.
- M822 (need with kc501) For Toyota 8A Key.
- Endoscope of XV100.
- SK1 for Toyota Bench-free Pincode-free Auto Key Coding.
Note: Accessories are not included, All the services/functions are not compatibility. Please check with us with your vehicle VIN.
XTool D8S Support 85+ Car Maker, 140+ Brands, Covered 10,000+ Cars:
XTool D8S all-in-one scanner is specially customized for large Maintenance Shops, Workshops, Car Dealers, Auto Mechanic. Work for 12V Petrol Sedans, SUVs, Minivans, Light-Duty Trucks across the globe.
Advance Hardware Configuration:
- Operating System: Android 10.0.
- Storage: 4G+64G.
- Processor: Quad core processor 1.5Ghz.
- Display: 1024 x 768 resolution.
- Screen: 8 inches touch screen.
- Sensor: Gravity Sensor.
- Audio Input: Microphone.
- Audio Output: Speaker.
- Interface: USB 3.0, DC Charging Port, VGA.
- Battery: 3.7V, 10000mAh.
- Input Voltage: 12V.
XTool D8S Packing List:
- D8S Main Unit.
- Quick Start Guide.
- Main Cable.
- Power Charger.
- USB3.0 Data Cable.
- Charger UE.
- Charger US.
- Charger UK.
- Packing List.
- Tool Kit Case.
- Carton Box.
You must be logged in to post a comment.